Dishwasher repair
No water coming in, a cloudy film on every glass or a beeping panel? A local technician comes to your home, tests the dishwasher and explains the fix before any work starts.
Open a question to see the usual causes and a quick check you can safely do yourself. If it does not help, call us and tell us what you found.
The valve under the dishwasher opens to let water in. If its coil fails or the screen clogs, the tub stays dry.
The float tells the dishwasher when the tub is full. If it sticks up, the dishwasher thinks it is already full.
A water line bent behind the dishwasher, or a shut-off valve under the sink left closed, stops the water before it gets in.
Check that the shut-off valve under the sink is fully open. Look for the float in the front corner of the tub and make sure it moves up and down freely.
Minerals in the water dry onto glass and plastic and build up in the spray arms over time.
Without rinse aid, water dries in spots and streaks instead of sheeting off the dishes.
If the water never gets hot enough, detergent does not dissolve fully and leaves a powdery film.
Fill the rinse aid dispenser and run an empty cycle with a dishwasher cleaner. Run the kitchen tap until the water is hot before you start a load.
If the latch switch loses contact, the dishwasher thinks the door opened and pauses the cycle.
This safety part cuts the heat if the tub gets too hot. When it trips, many models stop the cycle.
A failing board can lose its place in the cycle and stop at random points, often with a code or flashing light.
Open and close the door firmly until the latch clicks. Make sure no tall pan or utensil is blocking the door or the spray arms.
Water in the base pan sets off the leak sensor, and the dishwasher stops and drains as a safety measure.
A blocked filter slows draining, and many models flash a drain warning when the water does not leave in time.
If the lights flash in a pattern after a reset, the board is reporting a fault code we can read on site.
Count the beeps or flashes and note the pattern. Clean the filter at the bottom of the tub. Switch the dishwasher off at the breaker for five minutes and try again.
Something else going on with your dishwasher? Describe it on the phone and we will tell you what to check first.
(249) 402-4083Built-in under the counter or freestanding, we work on the dishwasher brands you find in most kitchens around town.
Brand not on the list? Call and tell us the make and model.
(249) 402-4083Hand-washing for a week gets old fast, especially with a full house. Our technicians work out of Wasaga Beach and book visits every day of the week.
We take calls and book dishwasher repairs from 7am to 11pm, Monday to Sunday, at your home or your cottage.
The technician checks the inlet valve, pump, heater, latch and controls, then explains the fault and the repair. Free service call and diagnosis when you go ahead with the repair.
Our repairs come with a 3-month warranty on the work. If the same problem comes back in that time, call us and we will take another look.
Dishwasher trouble at home or at the cottage? We cover Wasaga Beach and the towns along the south shore of Georgian Bay and inland.
Tell us what your dishwasher is doing: not filling, leaving film, stopping or flashing. We will call you back to pick a time, or you can call us now.
Hours: Mon to Sun, 7am to 11pm
Service call: Free service call and diagnosis when you go ahead with the repair
Request a dishwasher repair visit
We only use your details to arrange this repair.
Thank You!
Your message has been sent successfully. We'll get back to you shortly.
Your request is in. One of our Wasaga Beach technicians will call you soon to book a visit. If water is leaking, close the shut-off valve under the sink until we arrive.
